POLINI POLINI Hi-Speed E-Bike Bosch Version Active Line + Performance Line CX

THIS ITEM SHALL BE USED IN ACCORDANCE WITH THE NATIONAL LAWS CONCERNING TRAFFIC; IT CANNOT BE USED ON PUBLIC ROAD.

Warnings and instructions inside. Polini Hi-Speed is an electronic device studied for E-bike motors with the aim to increase the pedal assist mode exploiting at all the performance that the motor can offer. The assembly takes only a few minutes. It does not require any setting because it is self-adjusting. The device does not require any battery since it is self-recharging. The speedometer will always show half of the actual speed, and the same for the Kms travelled. To know speed and kms travelled it is enough to double the figures.

HI-SPEED ACTIVATION/DEACTIVATION

The Hi-Speed, using the lights button, presents a new function to activate or deactivate it. If the ebike does not have the lights function active, you can go to a Bosch authorized center and request activation. If the bike has the lighting system active, this function is already is enabled. After activation, it will be possible to use the lights button to activate or deactivate Hi-Speed. If the lights button is not available on the display, they are activated by pressing the + button for a few seconds.

The lights button activates or deactivates the device only when it is set to a speed of 25 km/h with the WALK function.

With this configuration you can activate/deactivate Hi-Speed by pressing the light button, even if you are pedaling.

If Hi-Speed has been activated with the WALK function at 50 km/h, it CANNOT be activated/deactivated using the lights button.

Attention: during the first meters traveled, the odometer could have a delay in the speed reading.